This board is currently undergoing changes. Registration for new members is currently disabled while some changes take place. If you'd like to register please drop us an email.
Jeffr wrote:Sorry, that's not the case. I used a logic analyzer and reverse engineered it. The position pin is just used to auto trim the front and when adjusting the RD.
The RD takes one pin in that does both up shift and down shift depending on the waveform.
manninen wrote:ok, might be just easier to buy handlebar cable set
Mike K. wrote:Manninen very clever entry point for the wire.
Users browsing this forum: Bing [Bot] and 5 guests