OUR NEW FORUM/BLOG IS NOW ONLINE IN BETA VERSION, WITH A SCHEDULED PUBLIC RELEASE NEXT WEEK. ANYONE WITH A USER ID FROM THE CURRENT FORUM HAS ALREADY HAD THEIR USERNAME IMPORTED TO THE NEW FORUM THOUGH PASSWORDS WERE NOT IMPORTED SO YOU'LL NEED TO USE PASSWORD RECOVERY TO GET A NEW PASSWORD. WHILE THE NEW FORUM IS NOT YET COMPLETE WITH ALL OF IT'S FEATURES IT IS FUNCTIONAL AND WE LOOK FORWARD TO SEEING YOU THERE.
Jeffr wrote:It's possible that it's point to point and repeated rather than being a true, fully shared bus. In that case you may only be seeing a fraction of the communication. Sounds like the connection to the junction box must be special in some way in any case. Maybe it handles termination of some kind.
I would guess that they repeat the signal to tolerate errors introduced by voltage swings when the servos start. The di2 pos signal seems to repeat for over a second. Although it is clocked much slower.
I have a really crappy USB scope at home but if it's a 1mhz signal it should be easy to make a high pass filter and see if I can interpret it. If I want to do anything meaningful at that frequency without hogging battery I need to be able to use the bus from a micro clocked no faster than that so I can't bitbang it in software. If it's too far from actual CANbus spec it might require a custom IC.
Thanks for the update. I should have a kit in a couple of weeks to look at. I'll cut some wires and stick the probes in circuit and report back.
Jeffr wrote:How can you tell that there is a direct connection from the shifters and the wire to the derailleurs? I can't see that on the PCB.
Can you tell me what frequency that oscillator is?
There is some print on the 4-8 pin surface mount components. Can you tell what they are? Probably just FETs or something?
Users browsing this forum: No registered users and 2 guests